Block %2 Transformation Not Available; Block %2 Spline Active At Transformation Change - Siemens Sinamics S120 Diagnostic Manual

7: The DRF movement for this axis cannot be executed as a velocity override of the path with
the handwheel is active and the axis belongs to the path
8: The DRF movement for this axis cannot be executed as the contour handwheel is active with
this handwheel and the axis belongs to the path
9: The DRF movement for this axis cannot be executed as the axis is a PLC axis with handwheel
override that is active with this handwheel
10: The DRF movement for this axis cannot be executed as the axis is active as reciprocating axis
with handwheel override with this handwheel
Reaction: Alarm display.
Remedy: Use the handwheel for one purpose at a time only.
Program Alarm display showing cause of alarm disappears. No further operator action necessary.
Continuation:
14401 [Channel %1: ] Block %2 transformation not available
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The required transformation is not available.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department.
Modify part program; program defined transformations only.
Check MD 24... $MC_TRAFO_TYPE_... (assigns the transformation to part program instruction).
Program Clear alarm with the RESET key. Restart part program
Continuation:
14402 [Channel %1: ] Block %2 spline active at transformation change
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A change of transformation is not allowed in a spline curve section. A series of spline blocks must be concluded.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14403 [Channel %1: ] Block %2 preprocessing and main run might not be synchronized
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Positioning axis runs cannot be accurately calculated beforehand. Consequently, the position in the MCS is not known
exactly. It might therefore be possible that a change in the multiple significance of the transformation has been per-
formed in the main run although no provision was made for this in the preprocessing run.
Reaction: Alarm display.
Remedy: Modify part program. Synchronize preprocessing run and main run.
Program Clear alarm with the Delete key or NC START.
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
179