Block %2 Auxiliary Function Programmed Incorrectly; Block %2 Unreleased Option Used (Identification %3) - Siemens Sinamics S120 Diagnostic Manual

14770 [Channel %1: ] Block %2 auxiliary function programmed incorrectly
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The permissible number of programmed auxiliary functions per NC block has been exceeded or more than one aux-
iliary function of the same auxiliary function group has been programmed (M and S function).
In the user-defined auxiliary functions, the maximum number of auxiliary functions per group in the NCK system set-
tings has been defined for all auxiliary functions by means of the MD11100
$MN_AUXFU_MAXNUM_GROUP_ASSIGN (default: 1)
For each user-defined auxiliary function to be assigned to a group, the assignment is effected through 4 channel-spe-
cific machine data.
Return jump from asynchronous subprogram with M02/M17/M30, whereby the M code is not alone in the block. This
is impermissible if the asynchronous subprogram interrupts a block with WAITE, WAITM or WAITMC. Remedy: Pro-
gram M02/M17/M30 alone in the block or replace via RET.
22010 AUXFU_ASSIGN_TYPE: type of auxiliary function, e.g. M
22000 AUXFU_ASSIGN_GROUP: required group
22020 AUXFU_ASSIGN_EXTENSION: any required extension
22030 AUXFU_ASSIGN_VALUE: function value
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Correct the part program - max. 16 auxiliary functions, max. 5 M functions per NC block, max. 1 auxiliary function per
group.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14780 [Channel %1: ] Block %2 unreleased option used (identification %3)
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Fine ID
Definitions: A non-released option has been used in the block.
Identifier Brief description
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
23
24
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
LaserCtrl option
ClearCtrl option
FeedAdapt option
AaTOff option
Tang option
LeadCtab option
ELG option
Trafo5 option
Traoem option
Transmit option
Tracon option
Tracyl option
Traang option
Oscill option
SynSpi option
Repos option
Spline option
Involute option
Poly option
Compress option
Masl option
ExtLang or ExtLanguage option not activated
NCK alarms
197