Amount Of Fine Correction In Parameter %2 Of Toolholder %3 Too Large; Toolholder No. %2 For Orientation Transformation %3 Does Not Exist; Invalid Trans. Type '%2' In Toolholder %3 For Orient. Transformer %4 - Siemens Sinamics S120 Diagnostic Manual

Program Switch control OFF - ON.
Continuation:
4334 [Channel %1: ] The amount of fine correction in parameter %2 of the orientable
toolholder %3 is too large
Parameters: %1 = Channel number
%2 = Invalid parameter of the orientable toolholder
%3 = Number of the orientable toolholder
Definitions: The maximum permissible value of the fine correction in an orientable toolholder is limited by the MD20188
$MC_TOCARR_FINE_LIM_LIN for linear variables, and by the MD20190 $MC_TOCARR_FINE_LIM_ROT for rotary
variables. The alarm can only occur if the SD42974 $SC_TOCARR_FINE_CORRECTION is not equal to zero.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Enter a valid fine correction value.
Program Clear alarm with the RESET key. Restart part program
Continuation:
4336 [Channel %1: ] Orientable toolholder no. %2 for orientation transformation %3 does not
exist
Parameters: %1 = Channel number
%2 = Number of the orientable toolholder
%3 = Number of the orientation transformation that is to be parameterized with the orientable toolholder
Definitions: The orientable toolholder, with whose data the orientation transformation is to be parameterized (see MD2....
$MC_TRAFO5_TCARR_NO_...), does not exist.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Enter a valid tool-carrier number.
Program Clear alarm with the RESET key. Restart part program
Continuation:
4338 [Channel %1: ] Invalid transformation type '%2' in toolholder %3 for orientation
transformer %4
Parameters: %1 = Channel number
%2 = Transformer type
%3 = Number of the orientable toolholder
%4 = Number of the orientation transformation that is to be parameterized with the orientable toolholder
Definitions: The parameters of the orientation transformation are taken over from the data of an orientable toolholder. This orient-
able toolholder contains an invalid transformation type. (Types T, P and M are permissible).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Enter a valid transformation type.
Program Clear alarm with the RESET key. Restart part program
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
39