Ring Coupling At Following Axis %3 And Leading Axis %4 Impermissible; Too Many Couplings For Axis %3, See Active Leading Axis %4; Block %2 Following Spindle/Axis Missing; Block %2 Master Spindle/Axis Missing - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
16778
[Channel %1: ] Block %2 coupling: Ring coupling at following axis %3 and leading axis
%4 impermissible
Parameters:
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Axis name, spindle number
Definitions:
A coupling has been switched on which results in a cyclic coupling, allowance being made for further couplings. This
cyclic coupling cannot be uniquely computed.
Reaction:
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy:
Please inform the authorized personnel/service department. Configure link in accordance with the MD or correct NC
part program (MD21300 $MC_COUPLE_AXIS_1).
Program
Clear alarm with the RESET key. Restart part program
Continuation:
16779
[Channel %1: ] Block %2 coupling: too many couplings for axis %3, see active leading
axis %4
Parameters:
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Axis name, spindle number
Definitions:
More leading axes and spindles were defined for the specified axis/spindle than are allowed. The last parameter to be
specified is a leading value object/leading axis to which the specified axis/spindle is already linked.
Reaction:
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy:
Modify part program.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
16780
[Channel %1: ] Block %2 following spindle/axis missing
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The following spindle/axis has not been written in the part program.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Modify part program.
Program
Clear alarm with NC START or RESET key and continue the program.
Continuation:
16781
[Channel %1: ] Block %2 master spindle/axis missing
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The master spindle/axis has not been programmed in the part program.
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
243
Hide quick links:
Advertisement
Table of Contents
