Block %2: Check Tool Carrier Position; Block %2: Cycle Cannot Be Executed With Nc Function %4; Block %2: %]Subroutine %4 Does Not Exist; Block %2: Contour Name %4 Too Long - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
61025 [Channel %1: ] Block %2: Check tool carrier position
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm triggered by following cycles: .
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Program Clear alarm with the RESET key. Restart part program
Continuation:
61026 [Channel %1: ] Block %2: Cycle cannot be executed with NC function %4.
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm triggered by following cycles: .
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Program Clear alarm with the RESET key. Restart part program
Continuation:
61027 %[[Channel %1: ] Block %2: %]Subroutine %4 does not exist
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE62
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check CYCLE62 call
- Check whether the subroutines specified on CYCLE62 call exist in the program storage
Program Clear alarm with the RESET key. Restart part program
Continuation:
61028 [Channel %1: ] Block %2: Contour name %4 too long
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE62
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - use shorter contour name
Program Clear alarm with the RESET key. Restart part program
Continuation:
376
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms