Block %2: %] Program Name Assigned Twice; Block %2: Maximum Spindle Speed For Main Spindle Not Entered; Block %2: Maximum Spindle Speed Not Entered For Counterspindle; Block %2: Programs Started From Various Job Lists: %4 - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
61051
%[[Channel %1: ] Block %2: %]Program name assigned twice
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm was triggered by the following cycles: CYCLE63, CYCLE64, CYCLE952
The same program name was assigned twice.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
When using CYCLE952, the name of the main program must not be the same as the name of the cutting file (PRG)
or the name of the updated blank contour (CONR).
When using CYCLE63 and/or CYCLE64, the name of the main program must not be the same as the name of the
program to be generated (PRG).
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61052
[Channel %1: ] Block %2: Maximum spindle speed for main spindle not entered
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm was triggered by the following cycles: CYCLE209, F_PARTOF, F_SUB_SP
Max. speed for main spindle was not entered.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Enter speed limit in program header or under settings.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61053
[Channel %1: ] Block %2: Maximum spindle speed not entered for counterspindle
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm was triggered by the following cycles: CYCLE209, F_PARTOF, F_SUB_SP
Maximum speed of counterspindle was not entered.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Enter speed limit in program header or under settings.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61054
[Channel %1: ] Block %2: Programs started from various job lists: %4
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm was triggered by the following cycles: CYCLE208
Programs from various job lists were started simultaneously.
This is illegal. All programs must be assigned to the same job list.
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
383
Hide quick links:
Advertisement
Table of Contents
