Block %2: Angle Of Aperture Programmed Too Small; Block %2: Text Length Programmed Too Small; Block %2: Polar Text Length > 360 Degrees - Siemens Sinamics S120 Diagnostic Manual

Program Clear alarm with the RESET key. Restart part program
Continuation:
61163 [Channel %1: ] Block %2: Infeed width in the plane too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The alarm is triggered by the following cycles: CYCLE899
Remedy: --
61175 [Channel %1: ] Block %2: angle of aperture programmed too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The angle of aperture of the text (_DF) in the engraving cycle is too small. This means that the text for engraving does
not fit in the specified angle.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Enter a larger angle of aperture.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61176 [Channel %1: ] Block %2: text length programmed too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The text length (_DF) in the engraving cycle is too short. This means that the text for engraving is longer than the spec-
ified text length.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Enter longer text length
Program Clear alarm with the RESET key. Restart part program
Continuation:
61177 [Channel %1: ] Block %2: polar text length > 360 degrees
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In the engraving cycle, the polar text length must not exceed 360 degrees.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Enter shorter text length.
Program Clear alarm with the RESET key. Restart part program
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
397