Block %2 Axis %3 Invalid Feed Type - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
Reaction:
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy:
Modify part programm.
Define the coupling and activate, if necessary, before the instruction.
Program
Clear alarm with NC START or RESET key and continue the program.
Continuation:
16698
[Channel %1: ] Block %2 following axis/spindle %3 leading axis/spindle %4 has not
been defined.
Parameters:
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Axis name, spindle number
Definitions:
An instruction to an undefined leading axis/spindle of a coupling is to be executed.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Modify part programm.
Define the leading axis/spindle and activate, if necessary, before the instruction.
Program
Clear alarm with NC START or RESET key and continue the program.
Continuation:
16699
[Channel %1: ] Block %2 following axis/spindle %3 leading axis/spindle %4 has not
been defined.
Parameters:
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Axis name, spindle number
Definitions:
An instruction to an undefined leading axis/spindle of a coupling is to be executed.
Reaction:
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy:
Modify part programm.
Define the leading axis/spindle and activate, if necessary, before the instruction.
Program
Clear alarm with NC START or RESET key and continue the program.
Continuation:
16700
[Channel %1: ] Block %2 axis %3 invalid feed type
Parameters:
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions:
In a thread cutting function, the feed has been programmed in a unit that is impermissible.
G33 (thread with constant lead) and the feed have not been programmed with G94 or G95.
G33 (thread with constant lead) is active (modal) and G63 is programmed additionally in a following block. (Conflict
situation! G63 is in the 2nd G group, G33, G331 and G332 are in the 1st G group).
G331 or G332 (rigid tapping) and the feed have not been programmed with G94.
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
235
Hide quick links:
Advertisement
Table of Contents
