Blank Must Be Closed Contour; Collision Through Approach; Axis In Negative Range - Siemens Sinamics S120 Diagnostic Manual

Remedy: - Check cutting edge position in tool management
Program Clear alarm with the RESET key. Restart part program
Continuation:
61739 %[[Channel %1: ] Block %2: %]Blank must be closed contour
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE952
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check whether the blank contour is closed
Program Clear alarm with the RESET key. Restart part program
Continuation:
61740 %[[Channel %1: ] Block %2: %]Collision through approach
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE952
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Select the starting position to enable collision-free approach of the contour
Program Clear alarm with the RESET key. Restart part program
Continuation:
61741 %[[Channel %1: ] Block %2: %]Axis in negative range
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE952
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check the position of the axis in the ordinate
Program Clear alarm with the RESET key. Restart part program
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
473