D Number %2 Defined In Tool T No. %3 And %4; D Number %2 Of Tools Defined On Magazine/Location %3 And %4; Block %2 Illegal T Number %3 - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: - Change program:
- Select different H number
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
17188 [Channel %1: ] D number %2 defined in tool T no. %3 and %4
Parameters: %1 = Channel number
%2 = Offset number D
%3 = T number of first tool
%4 = T number of second tool
Definitions: The specified D number %2 in the TO unit of channel %1 is not unique. The specified T numbers %3 and %4 each
have an offset with number %2. If tool management is active: The specified T numbers belong to tool groups with dif-
ferent names.
Reaction: Interface signals are set.
Alarm display.
Remedy: 1. Ensure that the D numbers within the TO unit are unique.
2. If unique numbering is not necessary for subsequent operations, do not use the command.
Program Clear alarm with the Delete key or NC START.
Continuation:
17189 [Channel %1: ] D number %2 of tools defined on magazine/location %3 and %4
Parameters: %1 = Channel number
%2 = Offset number D
%3 = Magazine/location number of first tool, '/' as separator
%4 = Magazine/location number of second tool, '/' as separator
Definitions: The specified D number %2 in the TO unit of channel %1 is not unique. The specified T numbers %3 and %4 each
have an offset with number %2.
If tool management is active:
The specified T numbers belong to tool groups with different names.
Reaction: Interface signals are set.
Alarm display.
Remedy: 1. Ensure that the D numbers within the TO unit are unique, e.g. by renaming the D numbers.
2. If unique numbering is not necessary for subsequent operations, do not use the command.
Program Clear alarm with the Delete key or NC START.
Continuation:
17190 [Channel %1: ] Block %2 illegal T number %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = T number
Definitions: In the displayed block, access is made to a tool that is not defined and therefore not available. The tool has been
named by its T number, its name or its name and duplo number.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
274
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms