Block %2 Repositioning After Switch Of Geometry Axes Or Transformation; Block %2 Master Spindle Not Defined; Rotary Axis/Spindle %2 Not Defined - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
10805 [Channel %1: ] Block %2 repositioning after switch of geometry axes or transformation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In the asynchronous subroutine the assignment of geometry axes to channel axes was changed or the active trans-
formation modified.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with the RESET key. Restart part program
Continuation:
10810 [Channel %1: ] Block %2 master spindle not defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The function "Revolutional feedrate" (with G95 or G96), or "Rigid tapping" (with G331/G332) has been programmed,
although no master spindle is defined from which the speed could be derived.
For the definition the MD 20090 $MC_SPIND_DEF_MASTER_SPIND is available for the default or the keyword
SETMS in the part program, thus allowing each spindle of the channel to be redefined as master spindle.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
Remedy: Preset the master spindle with MD20090 $MC_SPIND_DEF_MASTER_SPIND[n]=m (n ... channel index, m ... spindel
no.) or define it with an identifier in an NC part program before a G function that requires a master spindle is pro-
grammed.
The machine axis that is to be operated as a spindle must be equipped in MD35000
$MA_SPIND_ASSIGN_TO_MACHAX[n]=m (n ... machine axis index, m ... spindle no.) with a spindle number. Addi-
tionally, the MD20070 $MC_AXCONF_MACHAX_USED[n]=m (n ... channel axis index, m ... machine axis index) must
be used to assign it to a channel (channel axis index 1 or 2).
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
10820 [Channel %1: ] Rotary axis/spindle %2 not defined
Parameters: %1 = Channel number
%2 = Axis name, spindle number
Definitions: Revolutional feed has been programmed for contouring and synchronous axes or for an axis/spindle. However, the
rotary axis/spindle from which the feed is to be deduced is not available.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
Remedy: Correct part program or set the SD43300 $SA_ASSIGN_FEED_PER_REV_SOURCE correctly.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
94
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms