Island Is Outside The Pocket; No Residual Material Available; Cutter Radius For Residual Material Too Large; Radius Of Res. Material Cutter Too Small In Relation To Ref. Cutter - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
61949 %[[Channel %1: ] Block %2: %]Island is outside the pocket
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE63, CYCLE64
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check programming of the island/pocket contour
Program Clear alarm with the RESET key. Restart part program
Continuation:
61950 %[[Channel %1: ] Block %2: %]No residual material available
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE63
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program Clear alarm with the RESET key. Restart part program
Continuation:
61951 %[[Channel %1: ] Block %2: %]Cutter radius for residual material too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE63
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Use cutter with smaller radius
Program Clear alarm with the RESET key. Restart part program
Continuation:
61952 %[[Channel %1: ] Block %2: %]Radius of res. material cutter too small in relation to ref.
cutter
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE63
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Use a cutter with a larger radius for residual machining
Program Clear alarm with the RESET key. Restart part program
Continuation:
490
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms