Block %2: Code Page Not Present; Block %2: Character Does Not Exist, No.: %4; Block %2: No Name Assigned To Swivel Data Record; Block %2: Nck Software Version Is Insufficient For The Swivel Function - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
NCK alarms
61178
[Channel %1: ] Block %2: code page not present
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The specified code page is not supported by the cycle.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Use code page 1252.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61179
[Channel %1: ] Block %2: character does not exist, no.: %4
Parameters:
%1 = Channel number
%2 = Block number, label
%4 = Character number
Definitions:
The character entered in the text for engraving cannot be milled.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Enter another character.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61180
[Channel %1: ] Block %2: No name assigned to swivel data record
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Although there are several swivel data blocks, no unique names have been assigned. Alarm triggered by following
cycles: CYCLE800.
Remedy:
Assign unique name to swivel data block ($TC_CARR34[n]), if machine data 18088
$MN_MM_NUM_TOOL_CARRIER is >1.
61181
[Channel %1: ] Block %2: NCK software version is insufficient for the Swivel function
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Swivelling is not possible with the current NCK software version. Alarm triggered by following cycles: CYCLE800.
Remedy:
Upgrade NCK software to NCK 75.00 or higher.
61182
[Channel %1: ] Block %2: Name of swivel data record unknown: %4
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
the specified name of the swivel data block is unknown. Alarm triggered by following cycles: CYCLE800.
Remedy:
Check name of swivel data record $TC_CARR34[n].
398
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms
Hide quick links:
Advertisement
Table of Contents
