Block %2: No Counterspindle Step Found For Synchronizing; Assign Parameters For Main Spindle Chuck In The Spindle Chuck Data; Block %2: Block Search Element Not Found - Siemens Sinamics S120 Diagnostic Manual

61207 [Channel %1: ] Block %2: No counterspindle step found for synchronizing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No counterspindle step was found in any channel with which this channel could synchronize.
Alarm is triggered by the following cycles: F_SUB_SP.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Control program.
Delete step for synchronizing if it is not required.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61208 [Channel %1: ] Block %2: Assign parameters for main spindle chuck in the spindle
chuck data
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The parameters for the main spindle chuck in the spindle chuck data are not assigned.
Alarm is triggered by the following cycles: F_SUB_SP.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Indicate parameters ZCn, ZSn and ZEn in the mask "Parameters" > "Setting data" > "Spindle chuck data".
Program Clear alarm with the RESET key. Restart part program
Continuation:
61210 [Channel %1: ] Block %2: Block search element not found
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The element specified for the block search does not exisit.
Alarm triggered by following cycles: E_MANAGE, E_PS_CIR, E_PS_MRX, E_PS_POL, E_PS_SEQ, E_PS_XYA,
F_MANAGE, F_PS_CIR, F_PS_MRX, F_PS_SEQ
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Repeat block search.
Program Clear alarm with the RESET key. Restart part program
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
405