Smi: Component Found Without Motor Data; Profibus: Configuration Telegram Error - Siemens Sinamics S120 Diagnostic Manual

SINAMICS alarms
201840 <location>SMI: Component found without motor data
Message value: Component number: %1
Drive object: All objects
Reaction: NONE
Acknowledge: NONE
Cause: An SMI/DQI without motor data has been found (e.g. SMI installed as replacement part).
Alarm value (r2124, interpret decimal):
Component number from target topology.
Remedy: 1. Download the SMI/DQI data (motor/encoder data) from the data backup again (p4690, p4691).
2. Carry out a POWER ON (power off/on) for this component.
Note:
DQI: DRIVE-CLiQ Sensor Integrated
SMI: SINAMICS Sensor Module Integrated
See also: p4690 (SMI spare part component number), p4691 (SMI spare part save/download SMI data)
201900 <location>PROFIBUS: Configuration telegram error
Message value: %1
Drive object: All objects
Reaction: NONE
Acknowledge: NONE
Cause: A PROFIBUS master attempts to establish a connection using an incorrect configuring telegram.
Alarm value (r2124, interpret decimal):
50: Syntax error.
51: Connection established to more drive objects than configured in the device. The drive objects for process data
exchange and their sequence are defined in p0978.
52: Too many PZD data words for output or input to a drive object. The number of possible PZD items in a drive object
is determined by the number of indices in r2050/p2051 for PZD IF1, and in r8850/p8851 for PZD IF2.
53: Uneven number of bytes for input or output.
54: Cyclic operation not active.
55: Invalid operating state.
Remedy: Check the bus configuration on the master and slave sides.
Re alarm value = 51:
Check the list of the drive objects with process data exchange (p0978). With p0978[x] = 0, all of the following drive
objects in the list are excluded from the process data exchange.
Re alarm value = 52:
Check the number of data words for output and input to a drive object.
592
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms