How To Set The Ip Packet Transfer Function - Mitsubishi Electric MELSEC Q Series Reference Manual

4.3.2

How to set the IP packet transfer function

To use the IP packet transfer function, the following items need to be set.
Ethernet device
(request source device)
: Communication route
Ethernet device gateway address setting
1
IP address of the CPU module setting (
2
IP packet transfer setting (
3
This setting is required for the IP packet to be passed between a CPU module and a CC-Link IE Controller
Network module.
IP address setting of a CC-Link IE Controller Network module (
4
Routing parameters setting (
5
A communication route is set for communications with a different network.
and need to be set only for the CPU module connected to an Ethernet device.
2 3
● Ethernet device gateway address setting
Set the IP address of the CPU module connected to an Ethernet device in the gateway address of the Ethernet device
used.
• When the Ethernet device is a personal computer
It is recommended to configure the gateway address setting using the route command. (This only applies to an
Ethernet device having the route command such as Microsoft
If the gateway address is set in the default gateway, packets not related to the IP packet transfer are also
transmitted through the CPU module. Consequently, the service process of the CPU module drops under heavy
load, causing other service processes to be slow or other problems.
● Checking after the setting is completed
Execute the IP communication test to check for an error in the communication route. (
108
, , ,
Page 111, Section 4.3.2 (2) (a))
Page 238, Section 6.9)
, , ,
Page 111, Section 4.3.2 (2) (a))
Page 112, Section 4.3.2 (2) (b))
® ®
Windows .)
Ethernet device
(request destination device)
,
Page 113, Section 4.3.3)