Supplementary Settings - Mitsubishi Electric MELSEC Q Series Reference Manual

6.3.6

Supplementary settings

Set the constant link scan time, block data assurance per station, punctuality assurance, and the maximum number of
transient transmissions for one station.
1.
Open the "Assignment the CC IE Control Network Range" window in the programming tool.
( Page 183, Section 6.3)
2.
Click the
3.
Configure settings with reference to the description below.
4.
Click the
Item
Constant Scan
Block Data Assurance Block data assurance per station is
per Station available
Punctuality is guaranteed
Transient Setting
Maximum No. of Transients in One
Station
(1) Constant scan
Set a constant link scan time. (Setting range: 1 to 500ms, Default: None) (
(2) Block data assurance per station is available
Set whether or not to assure data integrity on a station basis. (Default: Block data assurance per station is
available)
If the "Block data assurance per station is available" checkbox is checked, link refresh is performed handshaking
between the CPU and CC-Link IE Controller Network modules, and thereby cyclic data integrity is assured in
units of stations. (
button.
button.
Set a constant link scan time.
Set whether or not to assure data integrity on a station basis.
Set whether or not to assure the punctuality of cyclic transmissions.
Set the number of transient transmissions that one station can perform in
one link scan.
Page 76, Section 4.1.5)
CHAPTER 6 PARAMETER SETTING
Description
Page 82, Section 4.1.7)
6
201