Cable Insertion Error - Mitsubishi Electric MELSEC Q Series Reference Manual

10.4.2

Cable insertion error

The following explains the procedures to be taken when OUT and IN of a cable are connected incorrectly.
(1) When a programming tool connected station is normally operating
Control
station Selected Normal station
No.1 station No.2
Normal station Normal station
No.4 No.3
Normal
station
Control station
No.2
No.1
Normal station Normal station
No.4 No.3
Selected
station
Select the own station.
A communication error has occurred between the OUT-side of the station
No.2 and the IN-side of the station No.4.
Select the faulty station (station No.2).
An error has occurred in the station No.2.
Click the error details button.
The Error Factor field indicates that a cable has not been inserted into
the correct port.
Take corrective actions according to the troubleshooting.
CHAPTER 10 TROUBLESHOOTING
545
10