Mitsubishi Electric MELSEC Q Series Reference Manual page 596

No. Name
IN-side mis-cabling
SW0082
station No.
OUT-side cable
SW0084 disconnection
detection count
Station-to-station test
SW0096
station
SW00A0
Baton pass status of
to
each station
SW00A7
594
Stores the station No. of the station where the IN-side cable is incorrectly
inserted.
The station No. to be stored is a station No. of the target station where a cable
is connected.
Station No.1 Station No.2
IN IN
OUT OUT
SW0082: 3 SW0082: 3
0: No station connects cable incorrectly
1 to 120: Station No.
(Condition)
• Valid when Baton pass status (own station) (SB0047) is OFF.
When Baton pass status (own station) (SB0047) is turned ON (error), data
prior to error is held.
• Valid when OUT-side loopback factor (SW0081) is 30
insertion error).
Stores the number (accumulation) of detecting cable disconnection at OUT-
side.
The number of detection is cleared when Clear OUT-side transmission error
counter (SB0008) is turned ON.
Stores the station No. of the target station where a station-to-station test is
performed. (Valid only at station-to-station test)
Stores the station No. of a target station when monitoring an executing station.
Stores the station No. of an executing station when monitoring a target station.
0: Station No. not set
1 to 120: Station No. for target station of station-to-station test
Stores the baton pass status of each station.
0: Baton pass normally operating station
1: Baton pass faulty station
b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0
SW00A0 16 15 14 13 12 11 10
SW00A1 32 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17
SW00A2
48 47 46 45 44 43 42 41 40 39 38 37 36 35 34 33
SW00A3 64 63 62 61 60 59 58 57 56 55 54 53 52 51 50 49
SW00A4 80 79 78 77 76 75 74 73 72 71 70 69 68 67 66 65
SW00A5 96 95 94 93 92 91 90 89 88 87 86 85 84 83 82 81
SW00A6 112 111 110 109 108 107 106 105 104 103 102 101 100 99 98 97
SW00A7
- - - - -
(Condition)
• Valid when Baton pass status (own station) (SB0047) is OFF.
When Baton pass status (own station) (SB0047) is turned ON (error), data
prior to error is held.
• The reserved station and the station No. later than the largest one are
excepted.
Description
Station No.3 Station No.4
IN IN
OUT OUT
SW0082: 2 SW0082: 2
(IN-side cable
H
9 8 7 6 5 4
- - - 120 119 118 117 116 115 114 113
Each number in the table represents station No.
Availability
Control Normal
station station
3 2 1