Chapter 6 Parameter Setting; Parameter List - Mitsubishi Electric MELSEC Q Series Reference Manual

Cc-link ie controller network
Hide thumbs Also See for MELSEC Q Series:
Table of Contents

Advertisement

CHAPTER 6
This chapter describes the parameters of the CC-Link IE Controller Network module.
6.1

Parameter List

This list shows the CC-Link IE Controller Network module parameters.
(1) Parameter list for the control station
Item
Network Type
Starting I/O No.
Network No.
Total Stations
Network
Settings
Group No.
Station No.
Mode
Station No. setting
method
System Switching
Monitoring Time
Data Link
Monitoring Time
LB/LW Settings
(1)
Network
LB/LW Settings
Range
(2)
Assignment
LX/LY Settings (1)
LX/LY Settings (2)
Specify I/O Master
Station
Shared Group
Setting
PARAMETER SETTING
Description
Select the station type of the CC-Link IE Controller
Network module.
Set the start I/O number of the CC-Link IE Controller
Network module in 16-point units.
Set a network No. of the network to which the CC-Link IE
Controller Network module is connected.
Set the total number of stations in one network.
Set a group No. for performing transient transmission by
group specification.
Set a station No. of the CC-Link IE Controller Network
module.
Select an operation mode of the CC-Link IE Controller
Network module.
For Universal model QCPUs, select how to set station Nos.
of normal stations.
Set a length of time that will be taken from a data link stop
(Data link status of own station (SB0049) turns ON) until
issue of a system switching request in units of 10ms.
Set the time for monitoring the link scan time in units of
5ms.
Set each station's send range in LB/LW to use it for
communication using LB/LW.
For each block, set an I/O master station and I/O ranges
used in communication using LX/LY between the I/O
master and relevant stations.
For a Universal model QCPU, set stations that will share
their cyclic data to the same Shared group No.
1) Safety CPU
2) Basic model QCPU
3) High Performance model QCPU
1) 2) 3) 4) 5) 6)
×

CHAPTER 6 PARAMETER SETTING

4) Process CPU
5) Redundant CPU
6) Universal model QCPU
CPU module
Reference
section
Page 180,
*1
*1
*1
*1
Section 6.2
×
×
×
×
×
*1
*1
*1
*1
Page 183,
Section 6.3
*1
*1
*1
*1
Page 185,
Section 6.3.1
Page 192,
Section 6.3.2
Page 196,
×
×
×
Section 6.3.3
177
6

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Melsec qj71gp21-sxMelsec qj71gp21s-sx

Table of Contents