(1) Setting data
Setting data
Jn
Un
(S1)
(S2)
(D1)
(D2)
(D3)
*1
Local devices and file registers for each program cannot be used as devices in setting data.
366
*1
Network No. of the own station (1 to 239, 254)
254: The network specified in Valid module during other station access
Start I/O number of the own station's CC-Link IE Controller Network module
(00 to FE
: The higher two digits of the 3-digit I/O number)
H
Start device of the own station that stores control data
(
Page 354, Section 9.5 (2))
The own station's start device where write data are stored.
Target station's start device to which data are to be written.
(A contiguous area for the write data length is required.)
The own station's device that is turned on for one scan upon completion of the
instruction
(D2)+1 also turns ON if the instruction execution has failed.
The target station's device that is turned on for one scan upon completion of the
instruction
(The target station can recognize that data have been written from the other
station.)
Description
Data type
Binary 16 bits
Device name
Bit