Mitsubishi Electric MELSEC Q Series Reference Manual page 455

*1
Setting data
Operation mode
n4
The own station's device that is turned on for one scan upon completion of the
(D1) instruction
(D1)+1 also turns ON if the instruction execution has failed.
*1 Local devices and file registers for each program cannot be used as devices in setting data.
● Remote STOP is available when the RUN/STOP switch of the target station CPU is set to "RUN".
● Remote STOP is not executable when system protect is applied to the target station CPU.
● If the target station CPU, for which remote STOP was performed, is reset, the remote STOP information is erased.
(2) Function
(a) RSTOP instruction overview
The RSTOP instruction executes remote STOP to the target station CPU.
The target station is specified in Target station network No. (Jn) and Target station No. (n2).
Upon completion of the request to the target station, the completion device (D1) turns ON.
[Own station]
CPU module
n4
RSTOP
(b) Target stations available for specification
• Target network
In addition to CC-Link IE Controller Network, stations in the following networks can be also specified.
• CC-Link IE Field Network
• MELSECNET/H
• MELSECNET/10
• Ethernet
• Target station's CPU type
The RSTOP instruction is executable only when the target station is QCPU, RCPU, or LCPU.
Description
b15
0001
[Target station]
CC-Link IE Controller
Network module
Channel 1
Channel n
Channel 8
CHAPTER 9 DEDICATED INSTRUCTIONS
to b0
(Fixed)
H
CPU module Network module
STOP
Data type
9
Binary 16 bits
Bit
453