Mitsubishi Electric MELSEC Q Series Reference Manual page 183

(1) Network Type
Select the station type of the CC-Link IE Controller Network module.
When the extended mode is selected using GX Works2, send points can be extended.
For a Basic model QCPU or safety CPU, it is fixed to "CC IE Control (Normal Station)".
Item
CC IE Control (Control Station)
CC IE Control (Normal Station)
CC IE Control Ext. Mode (Control Station)
CC IE Control Ext. Mode (Normal Station)
To use the extended mode, set a control station and a normal station in the same network to the extended mode.
The same network cannot contain different network types.
(2) Starting I/O No.
Set the start I/O number of the CC-Link IE Controller Network module in 16-point units.
(Setting range: 0000 to 0FE0
H
(3) Network No.
Set a network No. of the network to which the CC-Link IE Controller Network module is connected. (Setting
range: 1 to 239, Default: None)
When multiple network modules and/or Ethernet modules are mounted for one programmable controller, set different
network Nos. for them.
(4) Total Stations
When a control station is selected in "Network Type", set the total number of stations in one network.
(Setting range for Universal model QCPU: 2 to 120, Default: None)
(Setting range for other than Universal model QCPU: 2 to 64, Default: None)
(5) Group No.
Set a group No. for performing transient transmission by group specification. (
(Setting range: 1 to 32, Default: 0 (No group specification))
Set this for the CC-Link IE Controller Network control station.
(One control station is needed for a single network.)
Set this for the CC-Link IE Controller Network normal station.
Set this for a control station where send points can be extended. (GX
Works2 only)
Set this for a normal station where send points can be extended. (GX
Works2 only)
, Default: None)
H
CHAPTER 6 PARAMETER SETTING
Description
Page 102, Section 4.2.2)
6
181