Mitsubishi Electric MELSEC Q Series Reference Manual page 245

(3) Routing parameter setting example
The routing parameters for each station in the following system configuration are shown in this section.
Any station can transmit transient data to any other station.
1M 1 1N
P
Network No.1
1N 6 1N
S
(a) Routing parameters for each station of the network No.1
(b) Routing parameters for each station of the network No.2
(c) Routing parameters for each station of the network No.3
(d) Routing parameters of the relay station 1
(e) Routing parameters of the relay station 2
(4) Checking the routing parameter setting (communication test)
With a communication test in the programming tool, whether routing of transient transmission can be correctly
performed between the own station and a communication destination can be checked. (
5.7.1)
Verify that the routing parameter settings are correct.
2 1N 3
S S
(Relay station 1) (Relay station 2)
5 1N 4 2M 1
S S P
Network No.2
2N 2
S
No setting is required for the relay station 1 (1N
because data are transmitted via the own station.
No setting is required for the relay station 1 (1N
because data are transmitted via the own station.
No setting is required for the relay station 2 (2N
because data are transmitted via the own station.
No setting is required for the relay station 2 (2N
because data are transmitted via the own station.
CHAPTER 6 PARAMETER SETTING
3M 1 3N 2
P S
Network No.3
2N 4 3N 5 3N 4
S S S
2N 3
S
3N 3
S
4, 2M 1)
S P
4, 2M 1)
S P
4, 3N 5)
S S
4, 3N 5)
S S
Page 174, Section
243
6