Mitsubishi Electric MELSEC Q Series Reference Manual page 114

Item
Set the own network station where communications are transmitted through to reach the Ethernet device.
Set the routing parameters for all the CPU modules on the communication route.
Set the routing parameters as follows.
Target Network No.
Ex.
station
To transmit communications to the network No.
the IP packet passes through the station
with the own network No.
Relay Network No.
Relay Station No.
(b) Setting in the control station
(c) Setting in the normal stations
The IP address setting is not required for the normal stations.
The same network address as the control station is automatically assigned to the first and second octets. The
network number of the own station is assigned to the third octet, and the station number of the own station is
assigned to the fourth octet.
112
When the network address of the Ethernet device and CPU module is the same as that of the control
and station No.
Set parameters.
Ethernet device
(request source device)
Network No.
3.
Set the routing parameters.
Project window
Parameter]
For details on the routing parameters, refer to the
following. (
Description
, To transmit communications to the network No.
the IP packet passes through the station
. with the own network No.
Set parameters.
Station No. Station No.
Network No.
Network No.
1.
Open the "Network Operation Settings" window.
Project window
Parameter]
2.
In the "IP Address Setting" field, set the network
address.
Follow the rules to set the address. (
Section 4.3.2 (1))
[Parameter] [Network
[Ethernet/CC IE/MELSECNET]
button
Page 240, Section 6.9 (2))
,
and station No. .
Ethernet device
(request destination device)
[Parameter] [Network
[Ethernet/CC IE/MELSECNET]
button
Page 109,