Mitsubishi Electric MELSEC Q Series Reference Manual page 618

Station-specific parameter
Online operation Stop/restart of cyclic transmission
(b) Comparison of transient transmission functions
Read/write of other station word device
(READ/SREAD/WRITE/SWRITE)
Transient request to another station (REQ)
Data send/receive (SEND/RECV)
Read/write of other station word device (ZNRD/ZNWR)
Remote RUN, remote STOP (RRUN/RSTOP)
Read/write of clock data in other CPU module (RTMRD/RTMWR)
Group
Routing
Clock setting with a programming tool
Number of transient transmissions at one
scan
Changing number of
transient
transmissions
Maximum No. of transients in one station.
*1 In the CC-Link IE Controller Network system, transient transmissions can be performed to the following cyclic-
transmission-stopped stations:
• Station that is set as a reserved station, but exists on the network (Reserved station setting error)
• Station whose station No. is larger than the total number of stations per network (Invalid station
No. error)
616
Function
Function
Compatibility Precautions for replacement
Replace station-specific parameters of the
MELSECNET/H module with refresh
parameters of the CC-Link IE Controller
Network module. (
4.4 (4))
*1
: compatible,
Compatibility Precautions for replacement
Logical channel setting is not available for the
CC-Link IE Controller Network module.
Change the logical channel setting to channel
1 to 8. (
The CC-Link IE Controller Network module
does not have setting items.
The link scan time can be kept constant with
Cyclic transmission punctuality assurance in
the CC-Link IE Controller Network.
( Page 80, Section 4.1.6)
The same as the MELSECNET/H module
when removing a check from "Punctuality is
guaranteed" in the supplementary setting.
For the operation when marking a check, refer
to the following.
For the operation when marking a check:
( Page 80, Section 4.1.6)
Page 637, Appendix
None
: partially changed, —: incompatible
None
None
Page 641, Appendix 4.5 (2))
None
None
None
None
None
None