Mitsubishi Electric MELSEC Q Series Reference Manual page 53

(6) List of other functions
Function
Interrupt request to CPU module
Station No. setting by sequence
program
IP packet transfer function
*1 The area of LB/LW4000 or higher cannot be specified for interrupt conditions.
*2 CPU modules that can be used differ depending on the connection path. (
1) Safety CPU
2) Basic model QCPU
3) High Performance model QCPU
Description
Interrupt conditions are checked every link scan,
and if the conditions are met, an interrupt is
requested to the CPU module to start the interrupt
program.
For Universal model QCPUs, the station No. of a
normal station (own station) can be set in the
sequence program. (UINI instruction)
Communications in a protocol, such as FTP and
HTTP, using the specified IP address of an
Ethernet device can be performed over CC-Link IE
Controller Network.
With this function, two networks of CC-Link IE
Controller Network and Ethernet are not required,
resulting in reduced wiring cost.
CHAPTER 3 SPECIFICATIONS
4) Process CPU
5) Redundant CPU
6) Universal model QCPU
CPU module
Reference
1) 2) 3) 4) 5) 6)
*1 Page 135,
×
Section 4.5
Page 136,
Section 4.6
× × × × ×
Page 324,
CHAPTER 9
*2 Page 106,
× × × × ×
Section 4.3
: Available, : Partially available, ×: N/A
Page 107, Section 4.3.1)
3
section
51