Mitsubishi Electric MELSEC Q Series Reference Manual page 121

2.
Configure the IP packet transfer setting in the CPU module 1.
Project window
3.
Set the routing parameters in the CPU module 1.
Project window
button
4.
Set the IP address in the control station (station number 1).
Project window
5.
Write the set parameters to the CPU module 1. Then reset the CPU module 1 or power off and on
the system.
[Online] [Write to PLC]
[Parameter] [PLC Parameter]
button
[Parameter] [Network Parameter]
[Parameter] [Network Parameter]
button
RESET
or Power OFF
CHAPTER 4 FUNCTIONS
"Built-in Ethernet Port Setting"
[Ethernet/CC IE/MELSECNET]
[Ethernet/CC IE/MELSECNET]
ON
4
119