Mitsubishi Electric MELSEC Q Series Reference Manual page 43

(3) Software package
Systems using the CC-Link IE Controller Network module and software package are shown below.
To use the CC-Link IE Controller Network module, the programming tool is required.
System configuration
Q00J/Q00/Q01CPU
Q02/Q02H/Q06H/Q12H/Q25HCPU
Q02PH/Q06PH/Q12PH/Q25PHCPU
Q12PRH/Q25PRHCPU
Q00UJ/Q00U/Q01UCPU
Q02U/Q03UD/Q04UDH/Q06UDHCPU
Q10UDH/Q20UDHCPU
Q13UDH/Q26UDHCPU
Q03UDE/Q04UDEH/Q06UDEH/Q13UD
EH/Q26UDEHCPU
Q10UDEH/Q20UDEHCPU
QS001CPU
CPU modules other than the above
*1 Available functions differ depending on the version of the programming tool. (
*2 When using a GX Developer Version earlier than 8.68W, please interpret the description of "MELSECNET/G" as "CC-
Link IE Controller Network".
Single CPU system
Multiple CPU system
Single CPU system
Multiple CPU system
Single CPU system
Multiple CPU system
Redundant system
Single CPU system
Multiple CPU system
Single CPU system
Multiple CPU system
Single CPU system
Multiple CPU system
Single CPU system
Multiple CPU system
Single CPU system
Multiple CPU system
Single CPU system
Multiple CPU system
Single CPU system
Single CPU system
Multiple CPU system
CHAPTER 2 SYSTEM CONFIGURATION
Programming tool version
GX Developer
Version 8.68W or later
*2
Version 8.45X or later
Version 8.68W or later
Version 8.68W or later
Version 8.76E or later
*2
Version 8.48A or later
Version 1 Operating Manual
Version 8.76E or later
Version 8.62Q or later
Version 8.68W or later
Version 8.76E or later
Version 8.65T or later
Not available
Page 606, Appendix 3)
*1
GX Works2
Refer to the GX Works2
(Common).
41
2