Mitsubishi Electric MELSEC Q Series Reference Manual page 319

(b) Checking parameter status of own station
1.
When receiving parameters is completed, Parameter receive status (SB0054) is turned OFF.
2.
When parameters have an error, Received parameter error (SB0055) is turned ON and an error
code is stored in Parameter setting status (SW0055).
3.
The presence or absence of parameters can be checked with Parameter information (SW0054).
No.
SB0054 Parameter receive status
SB0055 Received parameter error
4.
When the parameters are reflected in the CC-Link IE Controller Network module, contents of
parameters are stored in the following link special relay (SB) and link special register (SW).
No.
SB0040 Network type (own station)
SB0043 Online switch (own station)
SB0044 Station setting (own station)
SB0048 Control station status (own station)
SB0056 Communication status
SB005C I/O master station (Block 1)
SB005D I/O master station (Block 2)
SB005E Own station's CPU type
SB0060 Communication mode
SB0061 Cyclic transmission punctuality assurance
SB007F IP address setting status
SB00C0 Reserved station specification
Description
Description
—
—
—
—
CHAPTER 8 PROGRAMMING
No. Description
SW0054 Parameter information
SW0055 Parameter setting status
No. Description
SW0040 Network No.
SW0041 Group No.
SW0042 Station No.
SW0043 Mode status
SW0044 Station setting
SW0046 Module type
—
SW004C Shared group No.
SW0056 Current control station
SW0057 Designated control station
SW0059 Total number of link stations
SW005C I/O master station (Block 1)
SW005D I/O master station (Block 2)
—
SW0063 Communication mode
—
SW00C0
to Reserved station specification
SW00C7
8
317