Mitsubishi Electric MELSEC Q Series Reference Manual page 462

(1) Setting data
Setting data
"Jn"/Jn
"Un"/Un
n1
n2
n3
(D1)
(D2)
*1 Local devices and file registers for each program cannot be used as devices in setting data.
460
*1
Network No. of the target station (1 to 239, 254)
254: The network specified in Valid module during other station access
Start I/O number of the own station's CC-Link IE Controller Network module
(00 to FE : The higher two digits of the 3-digit I/O number)
H
Channel used by own station (1 to 8)
Specify the channel used by the own station. (
(1))
Target station No.
Specify the station No. of the target station.
(1) Station No. specification
When own station is Universal model QCPU: 1 to 120
When own station is other than Universal model QCPUs: 1 to 64
Specify the CPU module on the station to be accessed.
Set value
0000
H
03D0
H
03D1
H
03D2
H
03D3
H
03E0
H
03E1
H
03E2
H
03E3
H
03FF
H
When the instruction is executed with control system CPU (03D0
system CPU (03D1 ) specified, if system switching occurs at the target station,
H
the instruction execution may fail. (Error code: 4244
If the instruction has failed with the above error, execute it again.
Start device of the own station, in which clock data are stored (
461, Section 9.16 (2))
The own station's device that is turned on for one scan upon completion of the
instruction
(D2)+1 also turns ON if the instruction execution has failed.
Description
Description
Control CPU (The access target is the same as when
"03FF " is specified.)
H
Control system CPU (Redundant CPU only)
Standby system CPU (Redundant CPU only)
System A CPU (Redundant CPU only)
System B CPU (Redundant CPU only)
• Target station CPU (single CPU system)
• Multi-CPU No.1
• Control CPU (single CPU system)
• Multiple CPU system No.1
Multiple CPU system No.2
Multiple CPU system No.3
Multiple CPU system No.4
Control CPU
, 4248
H
String/
Binary 16 bits
Page 328, Section 9.2.2
Binary 16 bits
) or standby
H
)
H
Page
Device name
Bit
Data type