Mitsubishi Electric MELSEC Q Series Reference Manual page 94

(2) Stopping cyclic transmission
1.
Select the target station(s).
Target station
Specific station
Group
All stations
*1 Right-clicking on the "All Station Status" window and clicking [Cancel Select All] cancels all the selection.
2.
Select the "Link Stop" radio button and click the
• By executing "specific station", the cyclic transmission of 1N
3.
The target station will stop cyclic transmission.
While cyclic transmission is being stopped, the D LINK LED of the target station is flashing.
Remark
If cyclic transmission of the station connected to a programming tool (own station) is stopped with this function, the own
station is disconnected from the network and thereby all stations are displayed as faulty stations in the CC IE Control
diagnostics.
When cyclic transmission of the own station is resumed according to Page 93, Section 4.1.12 (3), all of them will change to
normal stations on the display.
Note that, if there is any other station that stops its cyclic transmission, the station will be displayed as a faulty station. (Cyclic
transmission of the station does not restart.)
92
Check the "Selective Status" checkbox of the target station.
Multiple stations can be selected.
Right-click on the line of the target group, and click [Group Selection].
Right-click on the "All Station Status" window, and click [Select All].
Cyclic transmission restart
1M 1
P
Programming tool
1N 4
S
*1
Specification method
button.
2 can be stopped.
S
1N 2
S
1N 3
S