Program Example Of A Multi-Network System; System Configuration - Mitsubishi Electric MELSEC Q Series Reference Manual

8.2

Program Example of a Multi-network System

The programming procedure of when communications are performed in a multi-network system is described in Page
287, Section 8.2.1 to Page 303, Section 8.2.4.
8.2.1

System configuration

Configure the system using the procedures described in this section.
(1) System configuration example
Configure the system shown below.
The following is multiple network system where CC-Link IE Controller Network modules on the control station
(1M 1) and normal stations (1N
P
The CC-Link IE Controller Network module of the control station (2M
Control station
1M 1
P
(2) Wiring example
Connect an optical fiber cable from the OUT connector to the IN connector.
2, 2N 2) are mounted on the slot 0 of the base units.
S S
Normal station
1N 2
S
Network No.1
CC-Link IE Controller
Network module
Control Normal
station station
1M 1 1N
P
IN OUT IN
OUT
1) is mounted in slot 1 of the base unit.
P
Control station
2M 1
P
Network No.2
Control
station
2 2M 1
S P
OUT
IN
CHAPTER 8 PROGRAMMING
Normal station
2N 2
S
Normal
station
2N 2
S
IN OUT
287
8