Table of Contents
Advertisement
Operating Procedure (cont'd)
term
7.
D
B presses the MSG key and receives ringback tone. Redial is automatically made to Station C and
Station C rings.
Service Conditions
1.
A message can be sent out only when the called station is either idle or busy.
2.
A message can be sent out during ringing, recall from Call Transfer-All Calls, or recall from Consultation
Hold-All Calls.
3.
A maximum of four messages can be received at one D
displays:
4.
A message is displayed only when the handset is resting on the switch hook.
5.
To clear the message, display the message and press "#"/"
1)
6.
If the MSG key is reset, the message is cleared.
7.
A message cannot be cleared by the message sender.
8.
If the second message is sent out from the same D
9.
If Call Transfer-All Calls service is set, a message is also transferred to the designated transfer destination.
10.
Messages are memorized in any D
Reminder key.
Programming
Setting by MSG key (D
STEP 1:
ASYD - System Data 1, Index 80, Bit 1. Message Reminder service-key used for Message Deletion
term
(D
)
0/1: # key / * key
STEP 2:
AKYD - Assign data to Feature key.
FKY = 6 (Message Reminder)
STEP 3:
ASFC - With respect to SFC of the stations that sets Message Reminder service, cancel the restriction
of SFI = 53. (SFI = 53: Message Reminder service)
Setting by SHF + Access Code (Individual Station)
STEP 1:
ASYD - System 1, Index 17, Bit 0. SHF + ACC Code during ringback tone.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Message Reminder - CCIS
RG
term
D
(a)
[Node A]
STN (c)
MESSAGE BUSY
term
term
)
RBT
CCIS
[Node B]
RBT
term
. If the fifth message terminates, the LCD
" on the key pad. (ASYD-SYS1 Index 80, Bit
*
term
, it is memorized as the second unique message.
on which the feature key has been programmed as Message
NE C
term
D
(b)
M-34
Page 935
Advertisement
Table of Contents
