Table of Contents
Advertisement
Service Conditions (cont'd)
3.
An Attendant Console is regarded as an ONS. The Attendant Console will follow the PAD values assigned
in ARTD.
4.
If PAD data is assigned by APAD command, this data overrides other PAD data assigned by ARTD,
except when switch settings on the 24DTR are set to ARTD fixed.
5.
PAD settings for the 8TLTR can be set using ARTD/APAD or a combination of switch settings and
ARTD/APAD.
6.
This service is used for each of the following connections:
STATION-TO-STATION CONNECTION
STATION-TO-ATT CONNECTION
CONNECTION VIA ATT
OUTGOING C.O. LINE CONNECTION FROM STATION
OUTGOING C.O. LINE CONNECTION FROM ATT
7.
If the impedance of the trunk does not match the impedance setting on the trunk, the PAD values will not
match the values in the previous tables.
Programming
Assignment of Telephone
STEP 1:
ASDT - Assign the station data.
STEP 2:
ASFC - Assign either ONS or OPS to the SFC of the station.
SFI = 50, RES: 0/1 = ONS (General Telephone) /OPS (Long Line Telephone)
Stations that have SFI 50 in ASFC set to a 0, will follow the PAD setting in PAD 2 of ARTD.
Stations that have SFI 50 in ASFC set to a 1 will follow the PAD set in PAD 2. PAD 2 settings
override the values set in PAD.
STEP 3:
ASYD - System 1, Index 4, Bit 6 affects Station-to-Station calls only. (0=6dB, 1=0dB)
Assignment of External Trunk
STEP 1:
ARTD - Assign route class data for the route number of the external trunk.
When assigning route class data, assign PAD control data between ONS and external trunk to CDN
30:PAD or CDN 32:PAD2.
Assign expansion route class data for the route number of the external trunk.
When assigning expansion route class data, assign PAD control data between OPS and external trunk
to PAD2 (CDN 32).
When PAD 2 is not assigned, the value assigned in PAD will be used.
STEP 2:
ATRK - Assign trunk data of external trunk.
STEP 3:
MBTK - Cancel the make-busy of the external trunk assigning by ATRK.
STEP 4:
APAD - Assign the PAD control data for tandem connection, station-to-trunk connections, and
outgoing/incoming connection. When assigning APAD for station-to-station connections, the OGPAD
parameter has no effect when assigned (only the ICPAD parameter is used).
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
RS-464A PAD
R-37
Page 633
Advertisement
Table of Contents
