FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
AHLSN - This data must be assigned to the NCN:
UGN:
TELN:
TYPE:
CON UGN: User Group Number of the called party (for TYPE=2)
CON ADC: The dialed number for the called party (for TYPE=2)
CON LRN:
CON TK:
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
Note 1:
in addition to ASYDL or ASYDN.
The current data should also be set in addition the above-mentioned command. The command to be set to
Note 2:
the node accommodating the calling party: ASYD/ASFC/ASDT/ASP
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Hotline - Outside
Note 1
User Group Number of the calling party
Telephone Number of the calling party
2 (The called party is an outside party)
3 (The called party is a trunk)
Logical Route Number of the called party (for TYPE=3)
Trunk Number of the called party (for TYPE=3)
H-9
Page 385