Table of Contents
Advertisement
O-2
O-2
General Description
This feature allows a user to dial a specified access code and enter a first-in, first-out queue, when encountering a
trunk busy signal. As soon as an OUTGOING TRUNK becomes available, stations in the queue will be called back
on a first-come, first-served basis.
Operating Procedure
When LEAST COST ROUTING - 3/6-DIGIT [L-5] is not provided
1.
Dial the trunk access code and receive busy tone.
2.
Press the switch hook and receive special dial tone.
3.
Dial the OUTGOING TRUNK QUEUING (OGQ) access code and receive service set tone.
4.
Replace the handset.
When LEAST COST ROUTING - 3/6-DIGIT [L-5] is provided
1.
Dial the trunk access code and receive PBX dial tone.
2.
Dial the desired number and receive busy tone.
3.
Press the switch hook and receive special dial tone.
4.
Dial the OGQ access code and receive service set tone.
5.
Replace the handset.
Service Conditions
1.
After an OUTGOING TRUNK becomes available, the user's station will ring for 30 seconds. If not
answered within that time, the station will automatically be dropped from the queue.
2.
When this feature is used in conjunction with SPEED CALLING - SYSTEM [S-3], or LEAST COST
ROUTING [L-5], where a sender is involved, the sender will automatically dial out the called subscriber
number when the handset is lifted.
3.
If the user wishes to remove himself from the queue prior to being rung, the specified cancellation code
must be dialed.
4.
Individual stations may only initiate one outgoing trunk queue at a time. Subsequent attempts will result
in a reorder tone.
5.
Stations may be restricted from using this feature in CLASS OF SERVICE - INDIVIDUAL [C-15].
6.
This feature is not available for an ATTENDANT CONSOLE [A-3].
7.
The maximum number of simultaneous OGQs per system:
1 IMG:
4 IMG/IPX-U: 256 calls
The queue slots are used commonly by OFF-HOOK QUEUING [O-7], INTER-OFFICE OFF-HOOK
QUEUING [I-11], and OGQ [O-2, 2D, 16].
8.
CALL PICKUP - GROUP [C-7] cannot be used to answer a call directed to another station using OGQ.
9.
OGQ is common to all Central Office-type trunk groups (COT, TIE, FX, WATS, etc.) in the system.
10.
OGQ call back will return to the originating station, not the CALL FORWARDING [C-2, 3, 5] terminating
station.
11.
OGQ is denied to a station line when the CALL BACK [C-1] or CALL HOLD [C-6] feature is already
activated.
12.
The Attendant cannot CAMP-ON [A-1] a call to a station that has activated OGQ.
Page 552
Outgoing Trunk Queuing
Outgoing Trunk Queuing
64 calls
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
