Table of Contents
Advertisement
C-60
Service Conditions (cont'd)
b.) When originating a call from a trunk Restriction for Tandem connections between the incoming
trunk and the outgoing trunk selected for the call where CALL FORWARDING - BUSY LINE
service occurs.
12.
When a caller places a call via OGCA (Outgoing Call Alternative) and when the first outgoing route and
the calling party are restricted, this service cannot be set. In this case, the service can be set via the
following procedure:
a.) assign a dummy route,
b.) clear the restriction between the dummy route and all the stations, and
c.) assign the dummy route as the first route of OGCA.
13.
When a destination of CALL FORWARDING - ALL CALLS - OUTSIDE has already been assigned,
even if the feature is restricted by the new office data or changing of Day/Night mode, the assigned data
can still be used or cancelled.
14.
This feature allows a call to terminate to a trunk outside of the FCCS network. Accordingly, the access
code + office code or the access code including office code is required before dialing the telephone number
to recognize the terminating node.
15.
When the incoming call is forwarding to the public network, be sure to add the outgoing access code +
destination area code or the outgoing access code including destination area code number before dialing
subscriber number.
16.
A call can be forwarded to a trunk in the remote node via FCCS link.
Programming
STEP 1:
ASYD - System Data 1, Index 5, Bit 0. Are access codes for CALL FORWARDING-BUSY LINE and
CALL FORWARDING-DON'T ANSWER the same or separate? 0/1: Same/Separate.
System Data 1, Index 69, Bit 7, and System Data 1, Index 5, Bits 1~3 for MULTIPLE CALL
FORWARDING.
STEP 2:
ANPD - Reserve a number level for feature access and cancel. Assign Connection Index, CI = N, H,
B; Normal, Hooking, and Busy (applicable to any feature assigned to this level). Assign NND in
accordance with a predetermined numbering plan.
STEP 3:
ASPA - Assign an access code to CALL FORWARDING-BUSY LINE Entry, SID = 10 and to CALL
FORWARDING-BUSY LINE Cancel, SID = 11. Assign Connection Status Index (CI) for Normal (N)
service.
STEP 4:
ASFC - Assign the stations to receive CALL FORWARDING-BUSY LINE a Service Feature Class
that allows SFI = 9.
Assign either SFI 25 CALL FORWARD outside-Local or SFI 26 CALL FORWARD OUTSIDE-Long
Distance. And assign SFI = 151 when CALL FORWARDING-OUTSIDE is performed, RSC of the
forwarding station is used.
STEP 5:
AKYD - For D
line/feature key. Assign Type:Function:CALL FORWARDING-BUSY LINE [1].
STEP 6:
ATNR - Allow tenant-to-tenant connection for Inter and Intra-tenant connections. Assign Tenant
Restriction Index (TRI) = 1. For this feature to be set by the Attendant Console assignment, assign TRI
= 3 for Inter and Intra-Tenant connection via the Attendant Console. This allows a station in one tenant
to be Call Forwarded to a station in the same or different tenant. Also assign TRI = 0, station-to-station
calling.
STEP 7:
ACFO - For tenant-wide CALL FORWARDING-BUSY LINE of an incoming DID and DIT calls,
assign CF = 1 for a destination (CFI) of either the Attendant Console or station.
Page 222
Call Forwarding - Busy Line - Outside
term
sets, CALL FORWARDING-BUSY LINE may be assigned to a programmable
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
