Table of Contents
Advertisement
P-4
Programming (cont'd)
System Data 2, Index 2, Bit 0. Type of sender signal for station? 0/1: DP/PB. Assign as appropriate.
(This data will only be used if the ARTD data of a specific route is assigned as DP/PB.)
System Data 3, Index 11. Normally assign data 00H for 128 milliseconds.
STEP 2:
ASDT - Assign D
(PB), TEC = 3, or Dial-Pulse/ Push button, (DP/PB).
STEP 3:
ATRK - Assign Originating Register Trunks (ORT) to the system in a quantity calculated from
expected traffic. Registers are located on levels 0-3 of any 8RST circuit card.
Also, senders must be assigned to the system in a quantity calculated from expected traffic. Senders
are located on levels 4-7 of any 8RST circuit card.
RT:
Trunk Route Number
Intra-office Route Number (901-931)
901-ATT
902-ORT
903-IRT
905-Sender 916-MFCR
909-DCFT 917-MFCS
TK:
TN:
RSC:
SFC:
STEP 4:
ARTD - Routes must be assigned as either PB, DP, or DP/PB. CDN 2:ONSG, Type of Outgoing
Signal Selection (ONSG) is assigned to each route as data "1", DP; data "2", PB; or data "3", DP/PB.
Page 580
Pushbutton Calling
term
, single-line stations, a Telephone Equipment Class (TEC) of 2; push button
Route Number
912-ORT for ATT
913-TCFT for ATT
915- Night ATT
919 to 926-Modem
Trunk Number
Tenant Number
Route Restriction Class
Service Feature Class
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
