Table of Contents
Advertisement
Service Conditions (cont'd)
16.
CALL QUEUING [C-9] and CALL WAITING LAMP [C-13] services are available when this service is
activated.
17.
The calling party cannot receive the message if the restriction between the incoming trunk and the
announcement trunk is not cleared.
18.
When this service is allowed in system data, the ATTENDANT OVERFLOW [A-105] feature cannot be
activated.
19.
When the external announcement machine is used, the announcement starts from the time when the PBX
acknowledges the announcement trunk answer, and ends at the time of the announcement trunk release.
20.
When activating this feature in an FCCS network, Digital Announcement Trunk (DAT) and the called
Attendant Console must be accommodated in the same node.
Programming
When the Delay Announcement service is provided immediately after the call is terminated
STEP 1:
ASYD - SYS1, Index 244. b5=0 (Announcement is provided immediately after the trunk call is
terminated to the attendant console)
STEP 2:
ARTD - Assign the route data of the Announcement Trunk
15: LSG = 5
28: ANS = 0 (Access to announcement trunk is controlled by the current operation (Timer
= 1 (Answer and Release Timings are determined by DAT itself or the external
Note:
When the external announcement equipment is used, assign "1" in ANS parameter.
STEP 3:
ATRK - Assign the trunk data of the Announcement Trunk.
STEP 4:
MBTK - Cancel the make-busy of the trunk assigned by ATRK.
STEP 5:
AAED - Assign the data to the announcement unit number and the route data, etc. assigned by ATRK.
EQP:
32
RT:
route number
TK:
trunk number
Only when M = 1, assign TK.
Note:
C:
I
R:
I
A:
0
M:
0/1 = Single connection/Multiple connection
STEP 6:
ASTD - Allow tandem connection between COT and the Announcement trunk.
STM = 0, STS = 2, ST = 1
STEP 7:
ARRC - Cancel the restrictions on the trunk route for Incoming Trunk and the route for the
Announcement Trunk.
ICRT:
OGRT:
ARI-D RES: 1
When the Delay Announcement service is provided after the ring back tone
STEP 1:
ASYD - SYS1, Index 242. Timer for Delay Announcement- Attendant (Duration of RBT)
Timer for duration of RBT = TC X MTC
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Delay Announcement - Attendant
Control).)
announcement equipment.)
Note
Route Number for Incoming Trunk
Route Number for Announcement Trunk
D-114
Page 313
Advertisement
Table of Contents
