Table of Contents
Advertisement
C-12
Interactions (cont'd)
5.
If ATTENDANT LOOP RELEASE [A-6] is not provided and CALL FORWARDING - DON'T
ANSWER [C-3] via the Attendant Console is provided, a call extended to a station via the Attendant
Console will wait at the station for the time set in Index 141 and will then be forwarded to the destination
station for the time set in Index 145. Index 145 is the total time before recall. When that time expires, the
call will return to the Attendant Console.
6.
When CALL FORWARDING [C-2, 3, 5] is in effect, the forwarding operation occurs before CALL
WAITING-TERMINATING is allowed, unless the CALL FORWARDING - OVERRIDE [C-26] feature
is applicable. If CALL FORWARDING-OVERRIDE [C-26] is used, the call will wait. After a call has
been forwarded, the call may wait at the new station if CALL WAITING-TERMINATING is allowed.
7.
BUSY VERIFICATION [B-3]: This feature is denied to a station that is in a CALL WAITING-
TERMINATING state.
8.
EXECUTIVE RIGHT-OF-WAY [E-1]: This feature is denied to a two-party connection that is in a CALL
WAITING-TERMINATING state.
9.
STATION HUNTING [S-7, 8, 9]: This feature takes precedence over CALL WAITING-
TERMINATING.
10.
LINE LOCKOUT [L-3]: CALL WAITING-TERMINATING is not allowed to a station in LINE
LOCKOUT [L-3]
11.
OUTGOING TRUNK QUEUING [O-2]: CALL WAITING-TERMINATING is not allowed on any
station involved in THREE-WAY CALLING [T-2].
Programming
STEP 1:
ASYD - System Data 1, Index 64, Bit 6. Leave as data "0".
System Data 1, Index 145. Assign the Recall Timer for a call extended by the Attendant Console that is
not answered. Normally assign data 00H for 30 seconds. (RAM data 9F for 30 seconds).
System Data 2, Index 10, Bit 6. Assign 1H for automatic.
STEP 2:
ASFC - Assign a Service Feature Index (SFI) of 11 to the station. SFI 5 & 6, RES = 1.
STEP 3:
ARTD - For CALL WAITING - TERMINATING to operate automatically for TIE Lines and DID
routes, assign CDN 46:CW, Call Waiting, as data "1".
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
ARTDN - For CALL WAITING - TERMINATING to operate automatically for TIE Lines and DID
routes, assign CDN 46:CW, Call Waiting, as data "1".
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
Note:
in addition to ASYDL or ASYDN.
Page 174
Call Waiting - Terminating
Note
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
