Table of Contents
Advertisement
Programming (cont'd)
STEP 7:
ASFC - Assign data "1" to SFI 14 of a Service Feature Class, the traffic of which is to be registered on
SMDR (Trunk Basis). Assign data "1" to SFI 58 of a Service Feature Class the traffic of which is to be
registered on SMDR (STN to STN Basis).
When SMDR for station-to-station calling is not used, both stations in communication must be restricted at
Note:
the SFI 58.
STEP 8:
ARNP - For the routes flagged for SMDR in ARTD, list the route number and the Outgoing Trunk
access code (OGC) or Outgoing Trunk Advance (OGCA) access code here. If LCR(S) is used, list the
route numbers and the LCR(S) access code.
STEP 9:
AMND - Assign the number of digits the register is to receive for every dialing code. List the Toll
Number ID Data code for the system to distinguish the Toll Dialing patterns for SMDR registration.
The dialing code listings are identical for LCR(S). Refer to the AMND descriptions for LCR-3/6-
DIGIT
[L-5]
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
ATDF - Assign time difference data if the time between the nodes and the UCT (Universal
Coordinated Time) may not be identical on a FCCS network. The assigned data (time difference
margin [Plus/Minus, Hour, Minute] between each FPC and the UCT) is to be written in Network Data
Memory (NDM) of the Network Control Node (NCN).
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
Note:
in addition to ASYDL or ASYDN.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Station Message Detail Recording (SMDR)
and TOLL RESTRICTION-3/6-DIGIT [T-7].
Note
S-10
Page 683
Advertisement
Table of Contents
