Table of Contents
Advertisement
O-6
Programming (cont'd)
S:
Station
A:
Attendant Console
SSTN: Special Station Number
STEP 3:
ASGD - This command defines what stations belong to the Special Incoming Group. Assign the
following:
TN:
Tenant Number
STN:
Station Number
F:
Function Number (0-7)
0:
Off-Hook Alarm
GN:
Group Number (1-7)
STEP 4:
ASFC - Assign a Service Feature Class that allows SFI 30 to stations that will have OFF-HOOK
ALARM.
STEP 5:
AAKP - Assign the Attendant Console Key Pattern. The ATN: Attendant Number (TRK No. for RTE
901); KYN = 1-6; and FUNC = 2. (The console must be in Night mode to assign this command.)
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
ASYDL - This data must be set to all the nodes.
System Data 1, Index 640, assign the Fusion Point Code (FPC) of the node providing the Attendant
Console.
Note 2
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
Note 1:
in addition to ASYDL or ASYDN.
Assign the self FPC at the terminating node.
Note 2:
The current data should also be set in addition the above-mentioned command.
The command to be set to the node that accommodates the attendant console: AAKP, ACFR (when the
destination is the Night ATT: ATNR)
The command to be set to all the nodes: ASYD, ASFC
Page 562
Off-Hook Alarm
Note 1
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
