Table of Contents
Advertisement
Service Conditions (cont'd)
When encountering all trunks busy
14.
This service feature is valid for outgoing station-to-trunk or tandem trunk-to-trunk connections.
15.
Automatic OUTGOING TRUNK QUEUING [O-2], OFF-HOOK QUEUING [O-7] and ROUTE
ADVANCE [R-6] are mutually exclusive with this feature. These features take priority over OUTGOING
TRUNK BUSY - ANNOUNCEMENT [O-21].
16.
ANNOUNCEMENT SERVICE is provided to FCCS nodes that have no announcement trunk using the
trunk in the remote node.
17.
When CALL FORWARDING - INTERCEPT/ANNOUNCEMENT [C-25] or CALL FORWARDING -
INTERCEPT / ANNOUNCEMENT - ATTENDANT [C-75] is used in an FCCS network, the additional
data shown below is required.
a.) The logical route number should be applied to the physical route that is provided the service.
b.) The restriction of route-to-route connection between FCCS nodes should be released.
18.
When using the FCCS network, CALL FORWARDING-INTERCEPT / ANNOUNCEMENT [C-25] or
CALL FORWARDING - INTERCEPT / ANNOUNCEMENT-ATTENDANT [C-75] is not provided for
the incoming call using AUTOMATED ATTENDANT [A-82], DIRECT-IN TERMINATION [D-7], or
REMOTE ACCESS TO SYSTEM [R-2].
19.
When using the FCCS network, the call forwarding for an incoming call routed to a dead level or an
unused number has priority over the announcement service for the incoming call.
Interactions
1.
Each route connected to an announcement machine is also an EQP. The same route can be assigned as
different EQP's. However, it is best to separate EQP functions by route.
2.
8TLT, 16 COT, or 4DAT card may be used.
Programming
STEP 1:
ACFO - Enable this feature by allowing CF = 3: CALL FORWARDING - INTERCEPT/
ANNOUNCEMENT. The CFI parameter will come up for assignment. An Attendant Console may be
programmed so that intercepted calls will terminate at the CALL FORWARD INTERCEPT key. If no
assignment is made, the NEAX2400 IPX program goes to the AAED command for announcement trunk
information because the destination of the transfer is a trunk and not a station or Attendant Console.
STEP 2:
ARTD - Assign the announcement route as shown below:
RT:1
1-OSGS
8-RLP
*If a PA-8TLTR is used, assign as 5, E & M.
Note:
STEP 3:
ATRK - Assign the LENs, Announcement Trunk Route Number, Trunk Number, and Tenant Number.
STEP 4:
MBTK - Assign the Make Idle status to the Announcement Trunk.
Note:
If supervision is required, use the first two circuits of the 16COT circuit card. Move the switch on the 16COT
to PGT.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Call Forwarding-Intercept / Announcement
:2
2-ONSG
:3
:2
15-LSG
:0*
16 COT
5-TF
:1
6-TCL
CKT 0
Voice Tip
Voice Ring
CKT 1
Supervisory Ground
Ring, not used
C-25
:1
7-L/T
:1
Page 197
Advertisement
Table of Contents
