Table of Contents
Advertisement
Programming (cont'd)
System Data 1, Index 288, Bit 5. Expanded SMDR Output for SMDR A Apparatus. 0/1 = Out/In
Service.
System Data 1, Index 290, Bit 5. Expanded SMDR Output for SMDR B Apparatus. 0/1 = Out/In
Service.
System Data 1, Index 292, Bit 5. Expanded SMDR Output for SMDR C Apparatus. 0/1 = Out/In
Service.
System Data 1, Index 294, Bit 5. Expanded SMDR Output for SMDR D Apparatus. 0/1 = Out/In
Service.
System Data 1, Index 296, Bit 0. Output of Calling Number (ANI Information). 0/1 = Out/In Service.
Assign data "1".
System Data 1, Index 300, Bit 0. 0/1 = Billing information is sent to the Main Node in Expanded
SMDR format if CENTRALIZED BILLING - CCIS [C-55].
STEP 2:
ASFC - Assign a Service Feature Class that allows SFI 14 to stations allowed STATION MESSAGE
DETAIL RECORDING [S-10].
STEP 3:
ARTD - Assign route class data for the C.O. trunk.
RT: 1
15-LSG
When Calling Number is output to SMDR:
RT: 1
10-SMDR :1
Assign Route Class Expansion Data: CNI - 1. SVI: 1645 = 1
When My Line is Prime Line, Call Id Change Display Key is effective while terminating or in
conversation.
When My Line is not Prime Line, Call Id Change Display Key is effective while in conversation.
However, display pattern returns to the original setting when answering, holding, or transferring the
call.
STEP 4:
ATRK - Assign trunk data for the C.O. trunk.
STEP 5:
MBTK - Cancel the make busy of the C.O. trunk.
STEP 6:
AKYD - Assign Call Id Change Display key. Assign Type:Function:CALL ID CHANGE DISPLAY
[113]. When Call Id Change Display key is pressed, display pattern on the LCD assigned by ASYD
command changes according to the conditions above.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
ASYDL - System Data 1, Index 576, Bit 0=1. Enable central SMDR polling method for fusion.
System Data 1, Index 241, Bit 4. 0/1 = No ANI output to SMDR/ANI output to SMDR.
System Data 1, Index 241, Bit 6. 0/1 = When the length of Caller ID exceeds the limit, only the former/
latter part of data appears on the LCD.
System Data 1, Index 390, Bit 0. Caller ID display pattern on the LCD. 0/1 = Calling Number/Calling
Name has priority.
System Data 1, Index 390, Bit 2. when using D
displaying Caller ID. 0/1 = Out/In service.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
MF ANI to SMDR
:3
50-DPLY
:1
Note
term
2-line LCD, the lower LCD can be used for
M-101
Page 537
Advertisement
Table of Contents
