NEC NEAX2400 IPX Programming Manual page 415

Feature programming manual

Hide thumbs Also See for NEAX2400 IPX:

Table of Contents

Service Conditions (cont'd)

IPTRK-related tandem connection is not available.

Any service not available on the FCCS network, is not available with this feature.

Tandem Path through function is not provided.

This feature supports QoS (Quality of Service) function.

When a system message indicates TCP link failure due to data congestion on the router or IP network, a

call cannot be made via an IPTRK circuit card. When a call is attempted despite this, the caller hears busy

When a system message, related to TCP link failure, is created during a call origination or speech, that

calls speech channel is automatically restored via patrol function.

When all lines of an IPTRK card are busy, alternate routing to C.O. line or tie line is available. Details on

alternate routing patterns are shown in the following table:

Analog C.O. Line

Analog Tie Line

FCCS over DTI

FCCS over ISW (IPX-U System)

FCCS over IP (using Cisco router)

FCCS over IPTRK (Point-to-

Point/Point-to-Multipoint)

CCIS over IP

PAD can be provided for Receive control only.

This feature does not support Broad Band Services H0, H1 of ISDN/CCIS line. This feature supports 1B

When FCH-FGH card is used for FCCS signaling, a maximum of 16 nodes can be connected via this

When FCH-FGH card is used for FCCS signaling, the NDM data broadcasting may not work normally via

the FCCS link.

This feature does not support any OAI/ACD service.

FCCS Networking via IP

FROM FCCS OVER

(POINT-TO-POINT/POINT-TO-MULTIPOINT)

Not Available

Available (via Sub Address-Addressing only)

TO FCCS OVER

(POINT-TO-POINT)

Not Available

NEAX2400 IPX Feature Programming Manual

NDA-24297, Issue 1