Table of Contents
Advertisement
A-127
General Description
This feature allows a called station to receive CALLER ID information (time, calling number and name) from
Central Office when a call terminates via the analog COT. The calling number received from the ISDN network,
MF-ANI information received from Central Office with the MF feature or the calling telephone number within the
PBX can change into CALLER ID information and be sent to the called station.
This feature is also provided for the analog station equipped with the function of receiving the calling number. This
function is called Analog Caller ID - Station by Modem Sender.
Operating Procedure
No manual operation is required.
Service Conditions
1.
This service is provided for analog stations.
2.
Message types of CALLER ID information sent to a called station are as follows:
•
04H: Calling Number Delivery Information (for Calling number)
•
80H: Call Setup (for Calling number and name, or reason not to inform.)
3.
When a call terminates via another station, the number of intermediate station will be sent. After that
station hangs up, the number of the originating party will not be sent: CALLER ID of the first termination
is only sent.
4.
If a calling number exceeds 10 digits, the first or last exceeded digits will be deleted according to system
data.
5.
This service is not provided if a call does not terminate directly on a line: in the case of termination using
such services as Call Pickup, Executive Right-of-Way.
6.
This service is not provided when a calling party is the Attendant Console.
7.
This service is not provided for the 1 A2 key telephone.
8.
This service is not available in boss-secretary service.
9.
The first ringing upon termination is 2-second ring and 4-second silence. A ringer pattern is provided from
the second ringing.
10.
The following firmware is required to be equipped on the circuit cards:
CIRCUIT CARD
PA-8COTBJ
PA-8LCBR
11.
The following are service conditions for Analog Caller ID - Station by Modem Sender:
a.) This service is also provided for analog stations equipped with the function of receiving the
calling number.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Analog Caller ID - Station
Analog Caller ID - Station
FIRMWARE
SW-317 8COTBJ PROG-A
SP-1122 CALL-ID PROG-A
SP-3190 8COTBJ PROG-A
SW-331 8LCBR PROG-A
SP-3207 8LCBR PROG-A
SP-1123 CALL-LC PROG-A
A-127
Page 75
Advertisement
Table of Contents
