Table of Contents
Advertisement
Interactions (cont'd)
4.
TRUNK LINE APPEARANCE and HOTLINE-OUTSIDE [H-9] are mutually exclusive. Both features
require the AHLS command, and the same station cannot be provided with two Hotline features.
Programming
STEP 1:
ASDT - Assign the station with the TRUNK LINE APPEARANCE as a virtual line (TEC = 18).
TN:
Tenant Number
STN:
Station Number
LENS: Line Equipment Number (6 digits)
TEC:
Telephone Class (1-31)
1: DP (10pps)
2: PB
3: DP/PB
12: D
13: Data Terminal Via D
14: Hotline
15: CAS Line
16: Data Terminal Via Data Module
18: Virtual Circuit
23: ISDN Terminal
27: Eight Conference Equipment
RSC:
Route Restriction Class (0-15)
For assignment of RSC, ARSC command.
SFC:
Service Feature Class (0-15)
For assignment of SFC, ASFC command.
STEP 2:
ARTD - Assign the route of the TRUNK LINE APPEARANCE as a ground-start, ring-down trunk.
RT: 1
1-OSGS
6-TCL
STEP 3:
ATRK - Assign the LENs, Route Number, Trunk Number, and Tenant Number. Assign one or more
trunks to a specific route used to be connected as a TRUNK LINE APPEARANCE.
STEP 4:
MBTK - Assign the make idle status to the trunks.
STEP 5:
ASFC - Assign a Service Feature Class that allows Brokerage Hot Line (SFI = 36) to the stations to
receive TRUNK LINE APPEARANCE.
STEP 6:
AHLS - Assign the following parameters for the station with the TRUNK LINE APPEARANCE:
HOT TN: Tenant Number.
STN:
TYPE:
CON RT: Assign the TRUNK LINE APPEARANCE Route.
TK:
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Trunk Line Appearance
term
term
:2
2-ONSG
:3
:1
7-L/T
:1
Station with the TRUNK LINE APPEARANCE.
For TRUNK LINE APPEARANCE, assign Type 3.
Assign the TRUNK LINE APPEARANCE trunk.
3-ISGS
:1
4-INSG
8-RLP
:2
15-LSG
T-23
:3
5-TF
:1/3
:1
44-PRV
:1
Page 769
Advertisement
Table of Contents
