NEC NEAX2400 IPX Programming Manual page 942

Feature programming manual

Hide thumbs Also See for NEAX2400 IPX:

Table of Contents

General Description

This service feature allows Inter-Office Direct-In Termination for a case where an incoming call addressed to a

station in a PBX from a C.O. line is to be terminated to a station belonging to a different PBX in the CCIS network.

Operating Procedure

A DIT call terminates to Node A.

The DIT call terminates to Node B through CCIS and rings station B in Node B.

Service Conditions

Bothway trunks can be used for DIRECT-IN TERMINATION, but incoming only trunks are

recommended.

It is not necessary to order special DID trunks as is required with DIRECT INWARD DIALING [D-8].

However, care should be exercised in the application of central office trunk hunting.

If the called party is busy, the following conditions apply:

a.) When the call is directly terminated, the call will ring until the called station becomes idle or the

call is forwarded to an attendant according to the system data.

b.) In case of the call terminated via tandem connection (the call is originated from C.O. line and

CCIS line is intermediate interface), the call waits for a certain time and tries to terminate to the

destination (the call is not forwarded to Attendant Console irrespective of the system data).

NEAX2400 IPX Feature Programming Manual

NDA-24297, Issue 1

Direct-In Termination - CCIS