Table of Contents
Advertisement
Interactions (cont'd)
4.
When more than one Attendant Console is installed, a Primary Attendant Console may be assigned
(AMAT command). This Attendant Console will control the implementation of DAY/NIGHT CLASS OF
SERVICE [D-15].
5.
If the Primary Attendant places the system into Night mode, the Night LED on the other consoles do not
light.
Programming
STEP 1:
ASYD - System Data 1, Index 9. Assign the number of Attendant Consoles in the system. This
provides information to the ASAT command.
System Data 2, Index 2, Bit 2. Is this a Primary ATTCON system? 0/1: No/Yes. (When Primary goes
into Night, tenant goes into Night.)
System Data 2, Index 2, Bit 3. Is this a normal ATTCON system? 0/1: No/Yes. (When all Attendant
Consoles go into Night, tenant goes into Night.)
STEP 2:
ATRK - To assign the Attendant Console: LEN # = MG, and UNIT. The Line Group is always 20 and
the Level is either 0 or 1. Assign as Route 901. Also assign a Service Feature Class (SFC 0) and a
Route Restriction Class (RSC 0) to the Attendant Console.
STEP 3:
ASAT - Assign a specific Attendant Number to the Attendant Console. See INDIVIDUAL
ATTENDANT ACCESS [I-6].
STEP 4:
AMAT - Assign one of the Attendant Consoles to serve as the Primary Attendant Console. This service
is assigned on a tenant basis. The Attendant Number will correspond to the Trunk number of that
specific console.
STEP 5:
MBTK - Make Idle the Attendant Console trunk.
STEP 6:
ATNR - Allow tenant-to-tenant connection for Inter- and Intra-tenant basis. Assign Tenant Restriction
Index (TRI) 1 for station-to-station calling; TRI 1 for Call Forwarding, TRI 3 for Call Forwarding set
by the Attendant Console; TRI 4 for Incoming calls to the Attendant Console.
STEP 7:
ASFC - Allow SFC 0 to all needed features.
STEP 8:
ARSC - Allow RSC 0 access to all routes via RRI 0, 1, 2 and 3.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Multiple Console Operation
M-4
Page 471
Advertisement
Table of Contents
